EMF Complete Survey Measurement Pattaya Thailand

So I was invited to measure the EMF fields in this condo in Pattaya Jomtien Thailand. It is a beautiful complex I must say. The owner was worried about EMF fields and also lay lines.

Here are the recommended EMF values by building biology standards, as you can see below Electric fields are best under 1 V/M, Magnetic under 20 nT and High-frequency fields under 0.1 MW/m2

Low-frequency fields

First I measured Magnetic Low-Frequency Fields that are measured in Nano Teslas. Everything above 20 nT is not perfect. As you can see in the picture the level of magnetic fields was around 10 nT which is perfect. Compared to the house in Bangkok, which had horrific EMF magnetic levels, this condo is perfect regarding Magnetic fields. It is important to measure the magnetic fields where the person is sleeping, so he gets undisturbed sleep.

I measured where the person is also sitting watching TV and the EMF magnetic levels fluctuated a bit but not to dangerous levels, even though there was an elevator on the outer side of the wall. So that was great. The max amount was 23 nT which is still great.

Next, I measured low-frequency electric fields that are measured in volts per meter V/M. The recommended max level should be 1 V/M or less. I measured all over the condo, where the person sleeps and where he sits, and the levels were under 1 V/M which is great. I must say this condo is built great regarding the low-frequency fields. The apartment is also on the top 7th floor. So if there is any magnetic interference from power lines outside, which are everywhere in Thailand, the condo has a large distance from them, so the person is not affected by any EMFs from these fields.

Also, the wiring inside the condo seems to be great because if the grounding is faulty as it happens many times in Thailand, these levels can be much higher.

High-frequency fields

The next step was measuring high-frequency fields which are measured in Micro Watts per square meter. They should be under 0.1 MW/m2.

This is impossible to reach without proper shielding. THere are many wifi modems in the condo, plus mobile emissions from mobile antennas that are placed everywhere in Pattaya. Especially now in the 5G craze, mobile towers are everywhere.

In the bedroom the high-frequency fields were strong. Around 50 MW/m2, which s strong based on the Swedish biology standards.

In the living room, the levels were also very strong. Around 20 MW/m2. This was really a quick assessment. The good thing about high-frequency fields is that they can be easily shielded with emf paint, emf curtains, etc so you get them down to safe levels. The owner of the condo bought the paint the curtains like we recommended to get the levels of emf down to under 1 MW/m2.

On the balcony, the levels of EMF increased to 50 MW/m2, which is not surprising. The situation in this condo is much better then in other condos I measured. The condo is on the inner side of the complex and surrounded and enclosed by other condo buildings. That is why the mobile tower emissions from 4G/5G towers are not so strong. If there would be no buildings in front of this condo, the emissions could go up to 1000 MW/m2. The worse situation is if you can see a mobile antenna from your window. Then you are fried by microwaves which can be 1000 – 10000 MW/m2 24/7. These emissions in this condo were not great, but compared to others they are relatively good.

Ley Lines

Ley lines I measured with L Antennas and they were running just next to the right side of the bed and the other one was crossing the bed at the bottom of the bed. I recommended moving the bed to the right a little bit to avoid that ley line.

Conclusion

The low-frequency fields were perfect. The high-frequency fields were not good, they were elevated. I recommended the shielding which is already being installed in this condo. You can order the shielding through our EMF store and it will be shipped from Europe in a few days only.